GoBoxes are designed to store and protect cameras, optics and lenses, pistols, delicate electronics, first aid supplies, range boxes, camping equipment, and beyond.

You can boost your internal protection and organization with LoadOut™ KOR® Protective Inserts, the Pack Attic™, Gear Cubes, and the MOLLE panel, which is compatible with GoBox 20 only.

No.

Yes, the Pack Attic™ and the MOLLE Panel (GoBox 20 only) will fit with KOR® panels but will take up some storage space.

GoBox 8: 9.5” x 7.6” x 7.31” | 24.3cm x 19.3cm x 18.5cm

GoBox 10: 12.9” x 9.3” x 5.1” | 32.9cm x 23.8cm x 12.9cm

GoBox 20: 16.5” x 11.4” x 6.7” | 42cm x 29cm x 17.2cm

GoBox 8: 12.2” x 10.2” x 8” | 31cm x 25.9cm x 20.3cm

GoBox 10: 14.2” x 11.8” x 5.7” | 36.3cm x 30.2cm x 14.7cm

GoBox 20: 17.9” x 14” x 7.4” | 45.7cm x 35.7cm x 19cm

GoBox 8: 292oz | 8650ml

GoBox 10: 342oz | 10110ml

GoBox 20: 723oz | 21370ml

GoBox  8: 4.2lbs | 1.89kgs

GoBox 10: 4.7lbs | 2.12kgs

GoBox 20: 6.8lbs | 3.07kgs

All GoBoxes are made from PC/ASA plastic.

Yes, GoBoxes meet the International Electrotechnical Commission’s IP65 and IP67 ratings, meaning they are dustproof, waterproof even when exposed to jet-propelled water, and fully submersible up to 1 meter of depth for up to 30 minutes.

Yes.

No, they are not designed to be used with food and drink. If you’re in the market for a cooler, check out our Tundra® Hard Coolers or Hopper® Soft Coolers.

Yes, each GoBox is constructed with passive pressure ventilation.

Yes.

Yes, all GoBoxes are covered for 5 years.

The GoBox 28 is ideal for storing camera equipment, production equipment, large optics, emergency tools kit, and travel gear. The GoBox 68 is designed to accommodate camera equipment, production equipment, large optics, telescopes, tripods, toolbox, travel gear, camp gear, fishing equipment (fly rod tube compatible), and hunting equipment (arrow tube compatible). The GoBox 88 is perfect for holding camera equipment, production equipment, large optics, telescopes, tripods, toolbox, travel gear, camp gear, and fishing and hunting equipment (arrow tube compatible).

The LoadOut® PackAttic™, LoadOut® MOLLE Panel, LoadOut™ KOR® Protective Inserts, and LoadOut™ Gear Cubes are all compatible with the GoBox 28, 68, and 88 Gear Cases. 

No, the gear cases themselves do not come with anything included, but you can kit your GoBox out with our lineup of compatible accessories.

Yes, the GoBox’s lid can be kitted out using either the LoadOut® MOLLE Panel or LoadOut® PackAttic™, whereas the payload can hold both LoadOut™ Gear Cubes and LoadOut™ KOR® Protective Inserts to keep gear organized and secure.

All of our GoBoxes are made from Defender Material which offers high impact strength, excellent UV and weather resistance, and strong heat tolerance.

Yes, each GoBox meets IP65 and IP67 international ratings to be 100% waterproof and fully submersible. 

No, they are not. 

No, it is not designed to be used with food and drink. If you’re in the market for a cooler, check out our Tundra® and Roadie® Hard Coolers or Hopper® and Daytrip® Soft Coolers.

Yes, each GoBox auto pressurizes to accommodate changes in heat, altitude, etc.

Each GoBox is designed to take a beating and wear those scars proudly. But, if dirt and debris begin to build up, a quick wipe down with a wet rag and dish soap will do the trick. 

The wheels, handle, and handle brackets of the GoBox 28, 68, and 88 can be replaced. 

Yes, it is eligible for 30-day returns. 

Yes, please check our warranty page here. 

No, it is not the same handle.

You bet. This new-and-improved cargo box has the addition of our tried-and-true HeftyHauler™ Handle for one-handed hauling, an updated latch design for easy, one-finger closing, and a new lid design for increased stackability.

Yes, GoBoxes meet the International Electrotechnical Commission’s IP65 and IP67 ratings, meaning they are dustproof, waterproof even when exposed to jet-propelled water, and fully submersible up to 1 meter of depth for up to 30 minutes.

The size of the cargo box you need mostly comes down to a matter of preference for your pursuit. But if we had to distill it down, the GoBox 15 is the perfect size to keep essentials dry, the GoBox 30 fits anything ranging from climbing gear to a camp pantry, and the GoBox 60 is big enough to be your personal gear locker.

Stackability is a key feature of our LoadOut® GoBox family. Two GoBox 15s fit on top of the GoBox 30 and three GoBox 15s or one GoBox 15 and one GoBox 30 fit on top of the GoBox 60.

The GoBox 15 fits one caddy, the GoBox 30 fits two caddies, and the GoBox 60 fits three caddies. Each GoBox comes equipped with one caddy.

The GoBox 30 and 60 each come with one divider, but the GoBox 60 can fit two.

No, it is not designed to be used with food and drink. If you’re in the market for a cooler, check out our Tundra® Hard Coolers or Hopper® Soft Coolers.

Yes, you can use YETI’s Tie-Down Kit on each GoBox size.

Yes.

Yes, all GoBoxes are covered for 5 years.

KOR® Inserts use vacuum-form technology to protect anything you put inside a GoBox. The inserts adapt their shape to snugly conform to any gear — cameras, lenses, pistols, fishing rods and reels — minimizing and dispersing any impact you encounter.

Each case has a corresponding size of KOR® Protective Insert, Pack Attic™ and Gear Cubes. The correct accessory options will appear on each individual GoBox page.

Go for it. For instance, you can easily pair the KOR® Protective Inserts and the Pack Attic™. Just be advised that each GoBox has only so much internal capacity and that stacking accessories will take up space.

Each case has a corresponding size of KOR® panel and a recommendation for how many panels to occupy the space.

Please refer to the info on this page to learn all about using KOR® Protective Inserts.

Yes.

Identify the puncture by allowing the panel to inflate, closing the valve tightly, then squeezing the panel and listening closely for where the air is escaping. Then, remove a patch from the kit and place over puncture.

Yes, there is a specific size and recommended amount of panels for each of GoBox 15, 30, and 60.

The exterior of the KOR® panel is made with nylon.

We fill KOR® Inserts with impact-absorbing cushioning pellets, technically called “media.” They’re specifically designed to reduce and disperse impact, going from soft to rigid as air is extracted from the panel via the pump.

Be careful around sharp objects, which can puncture the exterior of KOR® panels. To clean, simply wet a cloth with soap, scrub and rinse with water. 

Yes.

Yes, it’s covered for three years.

The Pack Attic™ allows you to store items under the lid of your GoBox, keeping key pieces of gear in sight and easily accessible.

Find the twist pegs under the lid of your GoBox and attach the Pack Attic™ to them.

Each size of GoBox has a corresponding size of Pack Attic™.

Yes, for instance you can use a Pack Attic™ with the KOR® Protective Inserts or the Gear Cubes. Just keep in mind that each accessory you add will occupy space in the GoBox.

Model

Width (in)

Depth (in)

LoadOut® GoBox 10 Pack Attic™

13.19

9.37

LoadOut® GoBox 20 Pack Attic™

17.13

11.50

LoadOut® GoBox 28 Pack Attic™

20.04

11.85

LoadOut® GoBox 68 Pack Attic™

32.48

13.82

LoadOut® GoBox 88 Pack Attic™

27.80

16.14

The LoadOut® PackAttic™ is made up of an ultra-durable polyester material.

No, the accessory on its own is not, but when placed inside the lid of a LoadOut® GoBox Gear Case, its 100% waterproof, dustproof, and fully submersible exterior keeps the accessory, and your gear, protected. 

The LoadOut® PackAttic™ does not need to be routinely cleaned, but if dirt and debris begin to build, you can spot clean the affected areas of the accessory with a wet rag and dish soap. 

Yes, it is eligible for 30-day returns.

Yes, it’s covered for three years.

The LoadOut® MOLLE Panel goes under the lid of your GoBox and is ideal for strapping down and organizing gear. It can be used to fasten a first aid kit, tie down your toolkit, or holster any other gear you need to keep secure, in view, and within easy reach. 

The LoadOut® MOLLE Panel can be installed to the lid of your GoBox using the twist pegs. It is perfect for giving pouches, tools, knives, and other equipment a secure place to hang for easy access and total visibility. 

Each one of the GoBox Gear Cases has a corresponding LoadOut® MOLLE Panel that’s specifically sized to fit inside the lid. 

Yes, the GoBox’s lid can be kitted out using either the LoadOut® MOLLE Panel or LoadOut® PackAttic™, whereas the payload can hold both LoadOutTM Gear Cubes and LoadOut™ KOR® Protective Inserts to keep gear organized and secure.

Our MOLLE Panel is made from ABS, Acrylonitrile Butadiene Styrene, which is a durable, impact-resistant plastic.  

Yes, it is eligible for 30-day returns.

Yes, it’s covered for three years.

The LoadOut® GoBox Shoulder Strap is compatible with the LoadOut® Gobox in sizes 8, 10, 15, 20, and 30. 

You can attach the LoadOut® GoBox Shoulder Strap to your GoBox 8, 10, 15, 20, or 30 by clipping it onto the metal latches.

The LoadOut® GoBox Shoulder Strap weighs 0.70 lbs or 0.32 kgs. 

The LoadOut® GoBox Shoulder Strap is made up of an ultra-durable polyester material. 

The LoadOut® GoBox Shoulder Strap does not need to be routinely cleaned, but if dirt and debris begin to build, you can spot clean the affected areas of the accessory with a wet rag and dish soap. 

Yes, it is eligible for 30-day returns. 

No, it is not. Please check our warranty page here. 

The LoadOut™ Gear Cubes come in three sizes and are perfect for keeping the gear in your GoBox most susceptible to tangles and scratches separate and secure. 

Yes, the LoadOut™ Gear Cubes are compatible with the GoBox 15, 30, and 60. 

The small LoadOut™ Gear Cube is compatible with the GoBox 8 and above, the medium LoadOut™ Gear Cube is compatible with the GoBox 10 and above, and the large LoadOut™ Gear Cube is compatible with the GoBox 20 and above. 

The LoadOut™ Gear Cubes can be used with our LoadOut® GoBoxes to help improve organization and secure loose items.